The PHORENTINES STUDY effect is produced in white. By adding color toners (colors with numbers from 0 to 49) different colors can be obtained. Depending on the toner dosing, 3 different shades of each color can be obtained. It is important not to add more than 1 toner in 2.5 liters of product and no more than 4 toner per 10 liters of product.

Prior to application, it is necessary to remove the surface water. During application, the ambient temperature should be between +10 and +30 ° C and the relative humidity of the air should be less than 85%. Apply a layer of Prix Primer.

First Layer:
Product: HOOK OR MARMORINO (white)
Consumption: about 500 ÷ 600 g / m²
The first layer should be laid evenly over the surface.
In the first layer, the product does not need to be colored.

Choose a color and add the required amount of toner to the white PHOENEEN STYLE Effect. Stir well to obtain a homogeneous mixture.

Product: STUKO (white or colored)
Consumption: about 220 ÷ 300 g / m²
Applies when the first layer is completely dry. Apply carefully to create a flat, opaque surface with no protrusions and dents. This layer will serve as the basis of the third layer.

Product: STUKO (white or colored)
Consumption: about 80 ÷ 100 g / m²
Applies when the second layer is completely dry. Stir the mixture and apply evenly until the desired result is obtained. Before the third layer is completely dry, polish the spatula to obtain a shine.

Wax protection: about 30 ÷ 50 g / m². Stir well before use. The surface to be waxed should be dry, wait for at least 48 hours. Apply wax by using a soft sponge, spread over 1 m² each time you cover the entire surface. Remove the wax residue on the surface with a cloth (nonwoven, microfibre, cotton or linen).

When the viscosity of STUCCI or MARMORINO is not sufficient for application, a Compressing Additive must be used. Add the product to the STUCCI or MARMORINO base and gently stir until complete homogenization. The increase in viscosity can be checked after a few minutes. If this viscosity is still not satisfactory, wait about 1 hour and after follow-up control, gradually add an additional thickener while continuing to shuffle to the desired result. Warning: Too high doses of Compression Additive may cause excessive product cure. One pack of Compression Additive / 32 ml is sufficient for STUCCI / 10 kg.

Primer: 150 - 200 g / m² per coat
Marmorino: 1000 - 1200 g / m² for the first layer
Stucco: 500 - 600 g / m² for the first layer
220 - 300 g / m² for a second layer
80 - 100 g / m² for a third layer
Waxes: 30 - 50 g / m²

Primer Primer: 1.44 ± 0.08 Kg / l
Marmorino: 1.56 ± 0.05 Kg / l
Stack: 1.56 ± 0.05 Kg / l
Wax: 0.90 ± 0.05 Kg / l

12 hours between the layers, 48 hours before the wax