Highly thixotropic: Suitable for horizontal and vertical joints
Low modulus - can withstand extreme joint movement
Does not contain solvent, silicone or isocyanate
High bond strength on nearly all surfaces Primer less adhesion on many different substrates No bubble formation,even in wet and humid conditions
Very good UV resistance
Over-paintable with water based paints
No shrinkage

Expansion and connection joints in the building industry
Sealing of joints in prefabricated buildings
Movement joints in high rise constructions
Sealing between window and door frames
Where joints have to be painted

Before the application, the tip of the cartridges is cut and a plastic cap is fixed.
The tip of the cap is cut according to the width of the surface and fixed to the cartridge gun.
The sausage package is cut from one edge and fixed to a suitable gun. Then the cap nut is screwed to the cylinder of the gun.
The joints should be filled at one time and without gaps during the application.
The surface of MS Flexi applied in the joints should be smoothened with a dampened spatula, glazing tool, joint iron or by hand immediately.

If used, the adhesive tape should be removed afterwards.
The opened packages should be consumed as quickly as possible.
The contaminate areas and used tools should be cleaned with white spirit or alcohol within 10 minutes. It is cleaned only mechanically after cured.
Joint width/depth ratio should be 2:1.

12 months conditional to complying with the aforementioned storage conditions.