Product properties

Colour: Black when dry
3.1 Technical data
BASIC DATA(for mixed product at 20 °C)
Mass density: approx.0,90 g/cm³
Solids content: approx.58 % by volume
Touch after dry: ½-1 hour
Overcoating interval: Min.2 hours
Theoretical spreading rate: 0,450kg/m²(Depending on surface permeability and porosity) per each coat.
 

Mixing Location

Choose a location to mix materials that is close to the court entrance and will not require the mixed materials to be carried over patios, walkways etc. A vinyl drop sheet is recommended to protect lawns when mixing and spillage that may occur when transferring the material from the mixing drum to pails.
Mix UNIRUBBER 367-40 and water together until materials are blended to a smooth, slightly thick but free flowing homogenous consistency. A wooden pad-dle can be used, however, a ¾" electric drill and mixing shaft is available from most tool rental stores and is certainly much easier to use.
Clean Up: Wash tools with water. If material has dried, use kerosene.
 

Surface Preparation

As with a standard Acryflex T system, surface preparation is extremely important. The surface must be smooth and level. All pavement repairs must be flush with the surrounding surface. The pavement surface must be cleaned entirely dust, dirt debris and all loose materials. New asphalt surfaces must be cure 30 days prior to application. Newly cured or rough textured asphalt surfaces should first be coated with Acrylic Resurfacer. New concrete surfaces must cure 28 days prior to application. Concrete surfaces should have a medium broom finish or similar roughed texture. They must never be steel trowel. Etch surface with phosphoric acid and apply Acrylic Primer.
Using a soft rubber squeegee apply surface coating by walking beside the wind-row of wet material pulling the squeegee in even straight lines and on a slight angle to allow the material to flow in front of, and off the rubber squeegee blade.
Recommend a minimum 3 coats of UNIRUBBER 367-40 in order to get optimum shock absorbing quality.
Do not apply until preceding coat has dried.
 

Coverage Rates/Material Requirements & Ordering

Historic yield calculations for one coat are based on undiluted 50 kg pails of UNIRUBBER 367-40 and may vary according to texture, porosity and application technique within the following limits:
UNIRUBBER 367-40.............. 120 to 130 m2 per 50 kg pail for one coat.
Coverage rates may vary depending on the surface porosity, ambient tempera-ture and application technique.
 

Mixing Ratios (for 1 drum)

UNIRUBBER 367-40 ... 100 kg
Water.................... 20-25 kg
Important :The amount of water required will vary according to ambient tem-perature. Higher temperatures require greater water dilution to a maximum of 30% of the undiluted UNIRUBBER 367-40.
 

Drying Time

Thirty to sixty ( 30 to 60 ) minutes under optimum drying conditions. Indoor ap-plications are substantially affected by temperature and available ventilation and will dry more slowly.
 

Storage

The product is stored in sealed containers placed at indoor dry warehousing premises within the temperature range from 14° C to 60° C. Shelf life (warranty) is 12 months from the production date in cool and dry place.