Portland cement, micro-reinforcing fibers, polymer binder, additives and mineral fillers.

Density of filling, g/m³ - 1100-1300
Adhesion to base:
-concrete, kPa ≥ 250 (requirement according to ETAG-004)
-as an adhesive ≥ 80 (requirement according to EN 13499, ETAG-004)
Capillary water absorption, kg / m2 min0.5 (EN 1015-18) - 0.16, class W2, requirement ≤ 0.2 according to EN 998-1
Thermal conductivity-λ at 10 ° C dry, W / m.K (EN 1745 Table A.12) - 0.47
Pressure resistance after 28 days, MPa (EN 1015-11) - 16.3 class CS IV requirement ≥ 6 according to EN 998-1
Bending resistance after 28 days, MPa (EN 1015-11) - 4.3
Diffuse resistance coefficient μ (EN 1745 Table A.12) - 5/20
Density of cured plaster, g / dm3 (EN 1015-10) - 1520
Approximate consumption, kg / m2:
at fix ~ 4-5
at reinforcement ~ 5-6

25 kg

The mixture is obtained by slowly adding it to the powdered state and
approximately 26-28% water (6.5-7 l of water per 25 kg of powder)
with constant stirring with an electric stirrer until it is agitated
homogenizes completely. The mixture is left for 10 minutes and then is left
stir again and, if necessary, add water to obtain
the desired consistency of the adhesive.

The material should be in closed bags. When working in enclosed areas, ensure good ventilation. When working with a wet glue, protect the eyes and skin to avoid alkaline reaction. The product is to be stored in dry places on pallets, protected from moisture.

12 months.